Excel Sheets

Excel Spreadsheets Engineering

Circular Column Design Based on ACI 318-05

The design of axially loaded circular columns is mainly governed by the column's cross-section and its material properties. This is because the load ...

Design for Concrete Beam with Penetration Based on ACI 318-05

Beam Penetration Method : In this, different colors of multi-layered are coated on inner surface of screen, normally the two layers of phosphorus ...

Anchorage to Pedestal Design Based on ACI 318-05 & AISC 360-05

Anchor reinforcement consists of longitudinal rebar and ties to carry anchor tension forces and shear forces, respectively. The Strut-and-Tie Model ...

Base Plate and Group Anchors Design Based on ACI 318-05 & AISC 360-05

The Column Base Plate connection is a rectangular steel plate welded to the bottom of a steel column. The steel plate sits on the top of a concrete ...

Plate/Shell Element Design Based on ACI 318-05

Plate elements are three- or four-node elements formulated in three-dimensional space. These elements are used to model heat transfer in thin ...

Pipe Concrete Column Design Based on ACI 318-05

The main attributes of concrete pipe apply to sanitary, storm sewers and culverts. Many attributes also may be applied to box sections used for ...

Development of Reinforcement Based on ACI 318-05

A development length can be defined as the amount of reinforcement(bar) length needed to be embedded or projected into the column to establish the ...

Reinforced concrete column capacity

Reinforced concrete is used for construction on a large scale, such as bridges, dams, piers, tall buildings and stadiums. It is most commonly used ...

BASE PLATE MOMENT

The design moment resistance of the base plate depends on the resistances of two T-stubs, one for each flange of the column. Whether each ...

BASE PLATE COMPRESSION

Base plate in compression. The resistance of concrete in compression is defined according to EN 1993-1-1 by the following formula. A temporary ...

Array

Design calculation is performed according to coal information and boiler parameters to determine fluidization velocity, bed material height (usually ...

Corbel Design Based on IBC 06 / ACI 318-08

corbel is a short cantilever projecting out from a column, a wall, or the side of a beam. ... ACI 318 restricts the term “corbel” to a member having ...

Excel Sheets
Logo
Enable registration in settings - general
Compare items
  • Total (0)
Compare
0