Calculation of depth and width of continuous beam:- Total depth = effective depth + diameter of bar/2 + clear cover size. Width of beam = Depth/1.5 ( width ...

Reinforced concrete, concrete in which steel is embedded in such a manner that the two materials act together in resisting forces. The reinforcing steel—rods, ...

A compact section means that the section can achieve the plastic moment with local buckling on the web or the flange. But a noncompact section is a section ...

A development length can be defined as the amount of reinforcement(bar) length needed to be embedded or projected into the column to establish the desired ...

A deep foundation is a type of foundation which is placed at a greater depth below the ground surface and transfers structure loads to the earth at depth. ... ...

A manhole is the name given to the construction of an access point to pipes in both sewage drains (foul) and surface water drains (storm). These access points ...

Cast-In-Drilled-Hole (CIDH) piles are commonly used in the construction of bridge structures, and refer to a construction method in which the reinforced ...

Isolated footings are designed to sustain the applied loads, moments and forces and the induced reactions and to ensure that any settlement which ...

Composite Beam Design with Verco Floor Deck Spreadsheet provides the analysis and design of composite beams. The input studs spacing must be based on ...

The term column applies especially to a large round support (the shaft of the column) with a capital and a base or pedestal, which is made of stone, or ...